Panels: Radionics 2000 Series (2112 and 2212) Keypads: D202, D220, D222, D223
Arm: Press  to Arm All; Press  to Partial Arm
Disarm: Enter Code (If you are still in exit time, just press [CLEAR] to disarm.)
Check Faulted Zones: Faulted zones display automatically when faulted.
Bypass Zone(s): Press [Zone #] + [*].
Smoke Reset: After silencing the siren by entering the code, press  + code to reset the smokes.
* If smoke has not cleared the alarm may resound. Clear the detector of smoke and repeat the sequence to reset.
Chime Mode On/Off: Press , the keypad will display the current setting.
To Change, enter code +  to turn off,  to turn on short beep,  to beep until the CLEAR key is pressed, or  to beep until the point closes.
Code Change: It is recommended that you contact your security company and make changes under their direction.
Enter , + [Old Code] + [New Code] same # of digits as old code, + [New Code] again.
Power Down Panel: Pull wire on NP7-12 battery. Then unplug the panel transformer if you know where it is. It is a beige box plugged into a nearby power outlet. If you can’t find it, then disconnect AC wire, the upper left terminal on board.
User Manual: D202A Manual